I have an FGRP4-Beta still running after it shows 100% complete. Do I continue to let it run? It is significantly higher than my average times for FGRP4.
Agreed, numbers are only estimates...99.9993% is consider 100% to Boinc but in fact is not when running the application. The last little bit of a unit can take awhile as the application cleans up and compiles the data so it can be returned properly. If the unit didn't find as much then it should end sooner once it reaches the 100% mark.
task running after 100%
)
Have you tried exiting Boinc and then restarting it and see if the work unit completes?
No. You know what...I should
)
No. You know what...I should try that. I ending up aborting the WU anyway since it's requirements had already been fulfilled.
Just let it run. It is going
)
Just let it run. It is going to end soon.
RE: Just let it run. It is
)
Agreed, numbers are only estimates...99.9993% is consider 100% to Boinc but in fact is not when running the application. The last little bit of a unit can take awhile as the application cleans up and compiles the data so it can be returned properly. If the unit didn't find as much then it should end sooner once it reaches the 100% mark.